Project Array OM 1/10/06 12:21 PM Page 11
TROUBLESHOOTING
If there is no soundIf the system playsmode. If it is not, check to see
from any of theat low volumes butwhether your receiver/amplifier
speakers:shuts off as volume
has other surround modes you
is increased:
Y Check that receiver/amplifiermay use.
is on and a source is playing.Y Check all wires and con-
Y In Dolby Digital or DTS modes,
nections between receiver/
Y Check all wires and con-make sure your receiver/
amplifier and speakers. Make
nections between receiver/processor is configured so
sure all wires are connected.
amplifier and speakers. Makethat the surround speakers
Make sure none of the speaker
sure all wires are connected.are enabled.
wires are frayed, cut or
Make sure none of the speaker
punctured.Y Review the operation of your
wires are frayed, cut or
DVD player and the jacket of
punctured.Y If more than one pair of main
your DVD to make sure that
speakers is being used, check
Y Review proper operation ofthe DVD features the desired
the minimum impedance
your receiver/amplifier.Dolby Digital or DTS mode,
requirements of your
and that you have properly
receiver/amplifier.
selected that mode using both
If there is no sound
coming from onethe DVD playerOs menu and the
speaker:If there is low (orDVD discOs menu.
no) bass output
Y Check the OBalance� control(1500 Array):
on your receiver/amplifier.
Y Make sure the connections
Y Check all wires and con-to the left and right OSpeaker
nections between receiver/Inputs� have the correct
amplifier and speakers. Make+ and �
sure all wires are connected.
Y Make sure the subwoofer
Make sure none of the
is plugged into an active elec-
speaker wires are frayed,
trical outlet.
cut or punctured.
Y Make sure the Power Switch
Y In Dolby Digital or DTS
? is on.
modes, make sure that the
receiver/processor is con-Y In Dolby Digital or DTS
figured so that the speaker inmodes, make sure your
receiver/processor is con-
question is enabled.
figured so that the subwoofer
and LFE output are enabled.
If there is no sound
from the centerY Adjust the Subwoofer Level
speaker:Control c.
Y Check all wires and connec-
tions between the receiver/If there is no sound
amplifier and speaker. Makefrom the surround
sure all wires are connected.speakers:
Make sure none of theY Check all wires and con-
speaker wires are frayed, nections between receiver/
cut or punctured.amplifier and speakers. Make
sure all wires are connected.
Y If your receiver/processor is
¨Make sure none of the speaker
set in Dolby Pro Logicmode,
wires are frayed, cut or
make sure the center speaker
punctured.
is not in phantom mode.
Y Review proper operation of
Y If your receiver/processor
your receiver/amplifier and its
is set in Dolby Digital or DTS
surround sound features.
mode, make sure the receiver/
processor is configured soY Make sure the movie or TV
that the center speaker isshow you are watching is
enabled.recorded in a surround sound
11 |